Gearboxes
Gearbox Manufacturing and Rebuilds
A gearbox is only as good as the gear set inside it. At Mass Gear we build, rebuild and upgrade industrial gearboxes around gears we cut ourselves — helical, bevel, spiral bevel, worm and planetary stages — so the parts that carry the load are made to the drawing, not to whatever is on the shelf.
Most gearbox work reaches us after a failure: a broken tooth, a pitted pinion, a bearing that took the shaft with it. We strip the unit down, measure every gear and shaft, and either manufacture replacements from the original drawing or reverse-engineer them from the worn parts. Each set is heat treated for its duty and inspected before assembly, then built up with new bearings and seals, so the box goes back to work on kilns, mills, crushers, conveyors and steel-plant drives ready for the load it was designed for.
Enquire about a gearbox
Send the nameplate, the ratio and a photograph of the damaged stage — or the drawing, if you have it. We quote from either.
What we take on
From one worn stage to the whole box
01
Replacement gear sets
Helical, spiral bevel, worm and planetary stages made to the original drawing, or reverse-engineered from the worn set.
02
Shafts and pinion shafts
Input, intermediate and output shafts with integral pinions, splines and keyways, machined to fit the existing housing.
03
Complete rebuilds
Strip-down, inspection, new gears where needed, new bearings and seals, then reassembly and a backlash and tooth-contact check.
04
Upgrades
Better steels and heat treatment for a box that keeps failing at the same stage, so the repair outlasts the original.
How a job runs
Five steps, one workshop
Every stage happens under our own roof, so nothing waits on a third party between the strip-down and the dispatch.
- Strip-down and measurement
- Failure analysis and drawing
- Gear and shaft manufacture
- Heat treatment and inspection
- Assembly and contact check
From the shop floor
Gallery — Gearbox gear sets





















