Maintenance · Crankshafts
Crankshaft Maintenance and Repair
A crankshaft turns rotation into stroke, and every revolution loads its journals, crankpins and webs. When it wears, the whole machine runs rough — knocking bearings, heat, vibration. Mass Gear repairs heavy crankshafts on our own lathes and brings them back to a true, round, balanced running condition.
The work starts with measurement: run-out along the shaft, wear and ovality on every journal and crankpin, and the condition of the keyways, tapers and fits. Worn surfaces are re-machined true and matched to the bearings that will run on them; shaft ends and fits are restored; and because we cut gears in-house, the gear or sprocket mounted on the crankshaft can be made new in the same workshop if it has worn with it. Each shaft is checked again before it leaves.
Enquire about a crankshaft
Send the machine, the crankshaft dimensions or drawing, and photographs of the worn journals. We tell you what can be recovered and how.
What we cover
Journal to drive end
01
Measurement and inspection
Run-out, journal and crankpin wear and ovality, and the condition of every fit, recorded before any cut is made.
02
Journals and crankpins
Worn bearing surfaces re-machined true and round on our lathes, matched to the bearings that will run on them.
03
Shaft ends and fits
Keyways, tapers, threads and bearing seats repaired so couplings and gears seat properly again.
04
Gears on the crankshaft
A worn gear or sprocket mounted on the shaft made new in-house and fitted, so the drive is renewed as one.
How a job runs
Back to a true-running shaft
Measurement, machining and the gear work all happen under one roof, so the shaft is not waiting on a second supplier.
- Cleaning and measurement
- Wear report and repair plan
- Journal and crankpin machining
- Fits, keyways and gear work
- Final run-out check















