Herringbone gear inside a drilling pump, Mass Gear

Mass Gear for Engineering Industries

Drilling Pump Maintenance

Maintenance · Drilling pumps

Drilling Pump Maintenance

Drilling pumps run against high pressure for long hours, and the power end takes the punishment: the gear set, the pinion shaft and the bearings that carry them. Mass Gear maintains and repairs drilling pumps with a focus on that drivetrain — the part that decides whether the pump keeps running.

We inspect the power end, measure gear and pinion wear, and repair or remanufacture whatever is past its limit. Because we cut herringbone and double-helical gears in-house — the gear types many pump drives depend on — a worn main gear or pinion shaft can be made new in our own workshop instead of waited for. Every part is checked before reassembly, and the mesh is set so the pump returns to work running smooth and quiet.

Enquire about a pump

Send the pump make and model, the symptoms and a photograph of the gear or pinion if it is already open. We advise on repair or replacement.

info@massgearseg.com
+20 100 981 0654

What we cover

The power end, from gear to seal

01

Power-end inspection

Strip-down, wear measurement and a clear report on what can be reused and what has to be replaced.

02

Main gear and pinion shaft

Herringbone and double-helical sets repaired or made new, matched as a pair for a quiet, even mesh.

03

Shafts, bearings and seals

Journal repair and bearing fits restored, with new bearings and seals fitted on reassembly.

04

Reassembly and mesh check

Assembled, aligned and checked for backlash and tooth contact before it leaves the workshop.

How a job runs

Back to drilling, step by step

The gears are cut in the same workshop that strips the pump, so a worn set does not stall the job.

  • Power-end strip-down
  • Wear measurement and report
  • Gear and shaft repair or manufacture
  • Reassembly with new bearings and seals
  • Mesh and alignment check

From the shop floor

Gallery — Drilling pumps and herringbone gears

From the shop floor · Drilling Pump Maintenance

Watch it being cut

Real footage from our workshop, posted to the Mass Gear Facebook page. Tap any frame to play.

  1. 01 Watch on Facebook
  2. Mass Gear@massgearseg · 20K+ followers

    Facebook

    Follow the shop floor

    Join 20,000+ followers seeing new work as it comes off the machines.

    Follow Mass Gear on Facebook

The range

Every gear we cut, in one place

Fifteen product families, from standard spur gears through to one-off drives cut to your own drawing.

Spur Gears

Straight-cut, parallel shafts

Read more

Helical Gears

Angled teeth, quiet running

Read more

Herringbone Gears

Double helix, no axial thrust

Read more

Internal Gears

Ring gears, compact drives

Read more

Worm Gears

High reduction, right angle

Read more

Bevel Gears

Intersecting shafts

Read more

Straight Bevel Gears

Straight-tooth conical

Read more

Spiral Bevel Gears

Curved teeth, smooth mesh

Read more

Epicyclic Gears

Planetary gear sets

Read more

Segment Gears

Partial arcs and sectors

Read more

Sprocket Gears

Roller-chain drives

Read more

Pinions

Shaft pinions and racks

Read more

Heavy Industry Gears

Large-module, high load

Read more

Special Gears

Made to your drawing

Read more

Mechanical Parts

Shafts, couplings, housings

Read more

Next step

Send us the drawing. We’ll quote the gear.

Module, tooth count, material, hardness, quantity — or just a photograph of the worn part. Whatever you have, we can work from it.

Chat with us