Helical gear train inside a gearbox, Mass Gear

Mass Gear for Engineering Industries

Gearboxes

Gearboxes

Gearbox Manufacturing and Rebuilds

A gearbox is only as good as the gear set inside it. At Mass Gear we build, rebuild and upgrade industrial gearboxes around gears we cut ourselves — helical, bevel, spiral bevel, worm and planetary stages — so the parts that carry the load are made to the drawing, not to whatever is on the shelf.

Most gearbox work reaches us after a failure: a broken tooth, a pitted pinion, a bearing that took the shaft with it. We strip the unit down, measure every gear and shaft, and either manufacture replacements from the original drawing or reverse-engineer them from the worn parts. Each set is heat treated for its duty and inspected before assembly, then built up with new bearings and seals, so the box goes back to work on kilns, mills, crushers, conveyors and steel-plant drives ready for the load it was designed for.

Enquire about a gearbox

Send the nameplate, the ratio and a photograph of the damaged stage — or the drawing, if you have it. We quote from either.

info@massgearseg.com
+20 100 981 0654

What we take on

From one worn stage to the whole box

01

Replacement gear sets

Helical, spiral bevel, worm and planetary stages made to the original drawing, or reverse-engineered from the worn set.

02

Shafts and pinion shafts

Input, intermediate and output shafts with integral pinions, splines and keyways, machined to fit the existing housing.

03

Complete rebuilds

Strip-down, inspection, new gears where needed, new bearings and seals, then reassembly and a backlash and tooth-contact check.

04

Upgrades

Better steels and heat treatment for a box that keeps failing at the same stage, so the repair outlasts the original.

How a job runs

Five steps, one workshop

Every stage happens under our own roof, so nothing waits on a third party between the strip-down and the dispatch.

  • Strip-down and measurement
  • Failure analysis and drawing
  • Gear and shaft manufacture
  • Heat treatment and inspection
  • Assembly and contact check

From the shop floor

Gallery — Gearbox gear sets

From the shop floor · Gearboxes

Watch it being cut

Real footage from our workshop, posted to the Mass Gear Facebook page. Tap any frame to play.

  1. 01 Watch on Facebook
  2. Mass Gear@massgearseg · 20K+ followers

    Facebook

    Follow the shop floor

    Join 20,000+ followers seeing new work as it comes off the machines.

    Follow Mass Gear on Facebook

The range

Every gear we cut, in one place

Fifteen product families, from standard spur gears through to one-off drives cut to your own drawing.

Spur Gears

Straight-cut, parallel shafts

Read more

Helical Gears

Angled teeth, quiet running

Read more

Herringbone Gears

Double helix, no axial thrust

Read more

Internal Gears

Ring gears, compact drives

Read more

Worm Gears

High reduction, right angle

Read more

Bevel Gears

Intersecting shafts

Read more

Straight Bevel Gears

Straight-tooth conical

Read more

Spiral Bevel Gears

Curved teeth, smooth mesh

Read more

Epicyclic Gears

Planetary gear sets

Read more

Segment Gears

Partial arcs and sectors

Read more

Sprocket Gears

Roller-chain drives

Read more

Pinions

Shaft pinions and racks

Read more

Heavy Industry Gears

Large-module, high load

Read more

Special Gears

Made to your drawing

Read more

Mechanical Parts

Shafts, couplings, housings

Read more

Next step

Send us the drawing. We’ll quote the gear.

Module, tooth count, material, hardness, quantity — or just a photograph of the worn part. Whatever you have, we can work from it.

Chat with us