Toothed hub being turned on the lathe at Mass Gear

Mass Gear for Engineering Industries

Maintenance

Maintenance

Industrial Maintenance and Repair

When a drive stops, the cost is counted in hours of lost production. Mass Gear’s maintenance work is built around getting heavy equipment turning again — quickly, and with parts that will outlast the ones that failed.

We repair what can be repaired and remanufacture what cannot. Worn gears, pinions, shafts, couplings and housings come into our workshop, are measured and assessed, and leave either restored or replaced by new parts cut on our own machines. Because we make gears in-house, a repair is never held up waiting for an imported spare: if a part has to be made, we make it — from the original drawing, or by reverse-engineering the worn one.

Report a breakdown

Tell us the machine, what failed and how urgent it is — a photograph of the damaged part helps. We reply with the fastest route back to service.

info@massgearseg.com
+20 100 981 0654

What we maintain

The parts that keep a plant turning

01

Gear and pinion replacement

Worn or broken gears and pinions remade in-house, matched to the mating part so the set runs true.

02

Shafts and couplings

Journals, keyways and splines re-machined; new shafts and gear couplings made to fit where repair is not enough.

03

Drilling pumps

Power-end maintenance for drilling pumps: main gear, pinion shaft, bearings and seals.

Drilling pump maintenance

04

Crankshafts

Journals and crankpins re-machined true, shaft ends and fits restored, and the gear on the crankshaft made new if worn.

Crankshaft maintenance

Gearbox overhaul

A failed gearbox, rebuilt around new gears

From one worn stage to a full rebuild: gear sets cut in our own workshop, new bearings and seals, and a contact check before it goes back into service.

How a job runs

From breakdown to back in service

One workshop handles the assessment, the machining and the heat treatment, which is what keeps the turnaround short.

  • Assessment of the worn part
  • Measurement and drawing
  • Repair or remanufacture
  • Heat treatment and inspection
  • Back to service

From the shop floor

Gallery — Repair and remanufacture

From the shop floor · Maintenance

Watch it being cut

Real footage from our workshop, posted to the Mass Gear Facebook page. Tap any frame to play.

01 / 03 films

The range

Every gear we cut, in one place

Fifteen product families, from standard spur gears through to one-off drives cut to your own drawing.

Spur Gears

Straight-cut, parallel shafts

Read more

Helical Gears

Angled teeth, quiet running

Read more

Herringbone Gears

Double helix, no axial thrust

Read more

Internal Gears

Ring gears, compact drives

Read more

Worm Gears

High reduction, right angle

Read more

Bevel Gears

Intersecting shafts

Read more

Straight Bevel Gears

Straight-tooth conical

Read more

Spiral Bevel Gears

Curved teeth, smooth mesh

Read more

Epicyclic Gears

Planetary gear sets

Read more

Segment Gears

Partial arcs and sectors

Read more

Sprocket Gears

Roller-chain drives

Read more

Pinions

Shaft pinions and racks

Read more

Heavy Industry Gears

Large-module, high load

Read more

Special Gears

Made to your drawing

Read more

Mechanical Parts

Shafts, couplings, housings

Read more

Next step

Send us the drawing. We’ll quote the gear.

Module, tooth count, material, hardness, quantity — or just a photograph of the worn part. Whatever you have, we can work from it.

Chat with us